1. The heat transfer area is wide: the heat transfer tube of the cooler is designed with the thread of the copper pipe. The contact area is wide, so the heat transfer effect is higher than that of the smooth tube.

2, heat transfer is good: this series of copper tube is directly processed by the rotating heat, so that the heat transfer tube integration, so the heat transfer is good and indeed, there is no loss of solder joints caused by poor heat transfer.

3, suitable for large flow heat transfer tube number reduced, using oil flow area increases, and can prevent the loss of pressure. Equipped with a partition to guide the flow, can produce a curved flow, growth process, to play the effectiveness of.

4, good heat transfer tube with good thermal conductivity of copper is 99.9%, the most suitable for cooling the cooling pipe.

5, not because of the oil leak: the ontology and the board integration design, can avoid the mixture of water and oil problems, also in the factory after the tightness test is close, so it can achieve the purpose of preventing leakage.

6, easy assembly: the foot seat can be 360 degrees of freedom rotation and angle of ontology for free to change the direction of the assembly, the foot seat can be welded directly in any position or machine oil tank, convenient and simple.

7, spiral guide plate to guide the oil into a helical uniform flow, to overcome the traditional break flow generated by the dead end, high heat transfer efficiency, low pressure loss.

8, there are two flow and four flow, the flow of large flow (flow guide plate large lead) small flow (small guide plate), variety, can meet all kinds of requirements.